Warm Weather? You Can Still Save
Making your home energy efficient is cost-effective and better for the environment whatever the time of year. Here are just a few tips offered by the Department of Energy to help you save money and energy, winter spring, summer or fall:
- Insulate your "envelope" - Sealing and insulating the "envelope" or "shell" of your home — its outer walls, ceiling, windows, doors, and floors — is often the most cost effective way to improve energy efficiency and comfort. ENERGY STAR estimates that a knowledgeable homeowner or skilled contractor can save up to 20% on heating and cooling costs (or up to 10% on their total annual energy bill) by sealing and insulating.
- Insulate your water heater - Put an insulation wrap around the sides of your water heater. (But remember: Never put insulation on the top of the heater or near the bottom.)
- Seal air leaks - Warm air leaking into your home during the summer and out of your home during the winter can waste a lot of your energy dollars. One of the quickest dollar-saving tasks you can do is caulk, seal, and weatherstrip all seams, cracks, and openings to the outside. You can save on your heating and cooling bill by reducing the air leaks in your home.
Tips for Sealing Air Leaks
- Test your home for air tightness. On a windy day, carefully hold a lit incense stick or a smoke pen next to your windows, doors, electrical boxes, plumbing fixtures, electrical outlets, ceiling fixtures, attic hatches, and other locations where there is a possible air path to the outside. If the smoke stream travels horizontally, you have located an air leak that may need caulking, sealing, or weatherstripping.
- Caulk and weatherstrip doors and windows that leak air.
- Caulk and seal air leaks where plumbing, ducting, or electrical wiring penetrates through walls, floors, ceilings, and soffits over cabinets.
- Install foam gaskets behind outlet and switch plates on walls.
- Look for dirty spots in your insulation, which often indicate holes where air leaks into and out of your house. You can seal the holes with low-expansion spray foam made for this purpose.
- Look for dirty spots on your ceiling paint and carpet, which may indicate air leaks at interior wall/ceiling joints and wall/floor joists. These joints can be caulked.
- Install storm windows over single-pane windows or replace them with more efficient windows, such as double pane.
- Replace old equipment when possible - Replacing your old heating and cooling equipment with new, energy-efficient models is a great start. But to make sure that you get the best performance, the new equipment must be properly installed. In fact, improper installation can reduce system efficiency by up to 30 percent — costing you more on your utility bills and possibly shortening the equipment's life.
Learn more at U.S. Department of Energy’s Energy Savers site .